TM 5-3895-371-24 & P
c.
Disassembly. (Refer to fig. 2-33.)
(1)
Loosen square set screw (19); then lift off handle assembly (1).
(2)
Loosen two locknuts (17); then remove two screws and remove shaft from lever (11)
and control assembly (16).
(3)
Remove hub (7) with bushing (6) by removing capscrew (5), washer (8) and nut (9).
(4)
Remove bushing (6) from hub (7).
(5)
Tap out pin (2); then remove handle (3) and disk (4).
(6)
Remove spring (10).
(7)
Remove quadrant guard (14) by removing nuts (12) and (20) and capscrews (13).
(8)
Remove spring retainer (18).
d.
Reassembly, (Refer to fig. 2-33.)
(1)
Install spring retainer (18).
(2)
Install quadrant guard (14) and secure to quadrant control assembly (16) using nuts
(12) and (20) and capscrews ( 13).
(3)
Install spring (10).
(4)
Mount disk (4) and handle (3) in handle assembly (1); then secure with pin (2).
(5)
Install bushing (6) in hub (7).
(6)
Mount hub (7) onto handle assembly (1) and secure with capscrew (5), washer (8)
and nut (9).
(7)
Mount control assembly (16) and lever (11) on column (15). Locate centering hole
for lockscrew; then install lockscrews and secure with lock nut (17).
(8)
Mount handle assembly (1) on column (15) and secure with square set screws (19).
2-77
