TM 5-3895-371-24 & P
12-6. Discharge Header Strainer. (Refer to fig. 12-2.)
Preparation. Drain circulating system and spray bar. (Refer to TM 5-3895371-10.)
a.
b.
Removal.
Remove the header end cap (3) and gasket (2).
(1)
Remove the strainer (1).
(2)
c.
Cleaning, Inspection, and Repair.
(1) Clean all parts in an approved cleaning solvent. Dry thoroughly with clean, dry, com-
pressed air.
(2) Inspect the cap for cracks, breaks, damaged threads corrosion, distortion, or other
damage. Inspect the strainer for bends, breaks, tears, cracks, corrosion, or other damage.
Straighten bends or dents on the strainer. Replace the gasket. Replace strainer, if
(3)
damaged.
d.
Installation.
(1) Place strainer (1) in position inside the discharge header. Make sure the large end of
strainer is properly seated.
Install new gasket (2).
(2)
Install and tighten header end cap (3).
(3)
Figure 12-2. Disassemble/Assemble Header Strainer.
12-5/12-6 (Blank)
