Disassemble Override Control

TM-5-3895-371-24-P Bituminous Distributor Body M918 Model D-63 Manual
Page Navigation
140

TM 5-3895-371-24 & P

(7) Remove two short capscrews (35, fig. 3-4) and four long capscrews (19) and six lock-

washers (20). Lift off the pump cover (21). If the cover should stick to the housing, jar loose with a soft

faced hammer. Remove O-ring (23) and cover gasket (22) from pump cover. (See fig. 3-9.)

(8) Inspect the bearing (13, fig. 3-4) for galling of the rollers, roughness, or fracture of the

cage. If any of these conditions exist, press the bearing (13) from the pump cover (21). If the bearing

(13) is removed from the cover, then the bearing must also be replaced.

Disassemble Override Control. (Refer to fig. 3-10.)

(1)

Remove locknut (17), washer (18), and lever (19).

(2)

Remove two long capscrews (6), four short capscrews (8), and six lockwashers (2).

Figure 3-9. Removing the Pump Cover.

3-12