TM 5-3895-371-24&P
e.
(1)
Remove six capscrews (15) from end head (14) and remove head assembly,
(2)
Remove idler gear (11) from pin (13) on head (14).
(3)
Remove gaskets (12) from casting (8).
(4)
Pull out idler gear (11) and shaft assembly (10) from casting (8).
(5)
Remove packing glands (4) and (6), packings (5) and spring (7) from casting (8).
(6)
Press out bushings (9) from casting (8).
f.
(1)
Press in two pre-fit bushings (9) into pump casting (8).
(2)
Install idler gear ( 11) and shaft assembly (10) into bushings (9).
(3) Install spring (7), packing gland (6), packings (5) and packing gland (4) on shaft assem-
bly (10) and push into place.
(4)
Install gaskets (12) onto head (14) and idler gear (11) on head pin (13).
(5)
Install head (14) and secure with six capscrews (15).
(6) There should be no end play in the shah assembly (10) and very little to no drag on
shaft while turning by hand.
(7)
If shaft binds add one more gasket (12) until the binding is eliminated with no end
play.
2-96
