TM 5-3895-385-23-1
0111
Table 1. Left Screed Slope Fail to Raise Troubleshooting Procedures -- Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. If no leaks or damage is found,
proceed to next malfunction.
3. Loss of hydraulic pressure at
1. Check hydraulic hoses from load
1. If leaks or damage is found,
main hydraulic manifold.
sense hydraulic pump to main
replace damaged hydraulic
hydraulic manifold for leaks or
hose (WP 0291, Vol 2).
pinches (WP 0291, Vol 2).
2. If no leaks or damage is found,
proceed to next test.
WARNING
Hydraulic oil pressure is high enough to penetrate skin. Keep hands and body away from any
pressurized leak. Use cardboard or paper to check for leaks. Failure to comply may cause
injury or death to personnel.
Never disconnect a hydraulic fitting when the engine is on. Ensure engine is off and
BATTERY DISCONNECT switch is set to the OFF position. Failure to comply may cause
injury or death to personnel.
Hydraulic oil can be thrown when engine is running. Stop engine before checking engine
lubrication oil level. Failure to comply may cause injury or death to personnel.
Always cap or plug any disconnected hydraulic hose or fitting before starting the engine.
Failure to comply may cause injury or death to personnel.
Wear appropriate eye/face protection while performing maintenance. Failure to comply may
cause injury or death to personnel.
2. Attach hydraulic pressure tester
(WP 0442, Vol 3) to hydraulic
pressure test port on the main
hydraulic manifold (WP 0449,
Vol 3, Figure 3).
3. Start BMPM engine (TM 5-3895-
385-10).
0111-3