TM 5-3895-373-34
A.
REMOVE - Continued.
Fuel is very flammable and can
explode easily. To avoid serious
injury or death: Always wear safety
goggles/glasses at all times.
Keep fuel away from open flame or
any spark (ignition source).
Keep at least a B-C fire extinguisher
within easy reach when working with
fuel or on a fuel system.
Do not work on fuel system when
engine is hot; fuel can be ignited by a
hot engine.
Post signs that read "NO SMOKING
WITHIN 50 FEET" when working with
open fuel lines or fuel tanks.
d.
Remove fluid passage bolts (10 and 11) and
flat washers (12).
e.
Remove leak-off pipe (13) and flat washers (14).
f.
Plug and cap all exposed fuel fittings with
protective caps.
2.
REMOVE FUEL INJECTOR.
a.
Remove bolts (15) and clamp (16).
b.
Remove fuel injector (17).
c.
Remove and discard gasket (18) and spacer
(19).
NOTE
Washer (20) may not be attached to
the nozzle face of fuel injector (17)
when removed. Washer may need to
be removed from injector ports with
an o-ring tool.
d.
Remove washer (20) from fuel injector (17)
nozzle face. If washer is not on nozzle face, use
an o-ring tool to remove washer from injector
port (21).
e.
Plug injector port with protective cap.
GO TO NEXT PAGE
2-239
