TM 5-3895-373-20
REFERENCE INFORMATION
COLD START CONTROL CIRCUIT
Refer to TM 5-3895-373-10 for engine starting and equipment operating procedures. Refer to paragraph 2.10 for
connecting and disconnecting STE/ICE-R test set to DCA.
When ignition switch is turned to preheat, the induction
heater relay contacts should close, switching +12 vdc
through induction heater relay to the induction heater.
Remove engine access cover per paragraph 2.22 to gain
access to induction heater.
Refer to the electrical system diagram at the end of the
manual for equipment wiring details.
Refer to paragraph 7.21 for harness and lead wire repair.
Open rear top left access door per TM 5-3895-373-10 to
gain access to induction heater relay.
2-231
