Section XX. MAINTENANCE OF BITUMETER AIR CONTROL RESERVOIR

Figure 2-26. Remove/lnstall Bitumter Wheel, Tire and Bearing

Section XXI. MAINTENANCE OF PUMP TACHOMETER AND RECORDING BITUMETER

TM-5-3895-371-24P Melter Asphalt Skid Mounted Hot Oil Circulating 750 GPH Chausse Model STMD-3000A Manual
Page Navigation
73

TM 5-3895-371-24 & P Section XX. MAINTENANCE OF BITUMETER AIR CONTROL RESERVOIR 2-24. Bitumeter Air Control Reservoir. NOTE Close off main air pressure at supply tank and drain off air pressure by opening drain cock. Refer to TM 5-3895-371-10. a. Removal. (Refer to fig. 2-27.) (1) Disconnect two air lines (7) and (8) at elbows (6) and (9). (2) Remove two nuts (11), lockwashers (12), and capscrews (14) from brackets (13). (3) Spread air reservoir brackets (13) and remove air reservoir (1). (4) If air reservoir (1) is to be replaced, transfer all fittings to the new reservoir including two pipe plugs (18) and drain cock (10). LEGEND: 1. BUSHING RESERVOIR 7. AIR LINE 13. BRACKET (2) 2. BUSHING 8. AIR LINE 14. CAPSCREW (2) 3. NIPPLE 9. ELBOW 15. CAPSCREW (2) 4. CROSS PIPE 10. DRAIN COCK 16. LOCKWASHER (2) 5. VALVE 11. NUT (2) 6. ELBOW 12. LOCKWASHER (2) 17. CAPSCREW (2) 18. PIPE PLUG (2) Figure 2-27. Remove/Install Air Control Reservoir. TA 075833 2-66

Privacy Statement
Press Release
Contact