TM 5-3895-371-24 & P (3)Screw tube assembly (4) into valve and handle (3).(4)Screw pipe coupling (5) into tube assembly (4).d.lnstallation. To install the assembly (fig. 2-7), insert it into the two retaining clamps on thevehicle.Section X. MAINTENANCE OF HYDRAULIC PUMP PROPELLER SHAFT2-14. Hydraulic Pump Propeller Shaft.a.Removal. (Refer to fig. 2-9.)(1)Remove four capscrews (8) and washers (7) from rear yoke (9). Loosen set screw (17)in front yoke (18) at PTO.(2)Disconnect bracket (6) from vehicle frame by removing two capscrews (4), large washers(3), washers (2), and nuts (1). Remove hydraulic pump propeller shaft with attached bracket (6). Shaftmay be disassembled into two sections by disconnecting the splined gear in the center of the shaft (14).Press.(3)Press out bearing assembly (5) from bracket (6) and propshaft (14) with a suitable(4)Pulley (10) can be removed by removing four capscrews ( 12) and washers (7) andseparate pulley (10) from yoke (11).(5)Slide rear yoke (9) out of pump shaft. For replacing of journal bearing (13) and prop-shaft (16), see para 2-14 c.b.Installation.(1)Press new bearing assembly (5) on propshaft (14) and into bracket (6).(2)Connect the two sections of the shaft with yokes in alinement, by inserting the splinedgear of propshaft (14) into the yoke (15).(3)Assemble yoke (11) to pulley (10) and secure with four capscrews (12) and washer (7).(4)Slide rear yoke (9) on to pump shaft.(5)Mount assembled hydraulic pump propeller shaft with bracket (6) on vehicle and securethe bracket to frame with two capscrews (4), large washers (3), washers (2), and nuts (1).(6)Install washers (7) and capscrews (8). Tighten sat screw (17) in front yoke (18) at PTO.2-28
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
