TM 5-3895-37 1-24 & P
(5)
Remove eleven wire clips (6) and screws (7).
lamp.
(6)
At the two side facing amber clearance lamp assemblies, snip off brown wire at each
(7)
Remove fourteen wire clips (6) with screws (7).
(8)
Remove fiie wire clips (1) and screws (2).
(9)
At the upper rear tank clearance lamp, snip off brown wire.
(10)
Unscrew and remove six wire terminals (5).
b.
Inspection and Repair of Harness.
(1)
Inspect all outer harness and exposed wire insulation for damage or cracks.
Inspect all terminal ends for tight crimp.
(3)
Resolder terminal ends as necessary.
(4)
Replace badly cracked or corroded wires. Slight punctures in the outer insulation may
be wrapped securely with electrical tape.
C.
Installation of Harness. (Refer to fig. 2-3.)
(1)
Screw on six wire terminals (5).
(1)
Install new crimp connector to brown wire on lamp bar at the upper rear tank clearance
lamp and tape connection with waterproof electricians tape.
(3)
Install five wire clips (1) and screws (2).
(4)
Install fourteen wire clips (6) with screws (7).
(5)
Install new crimp connector to brown wire on side clearance lamps and tape connection
with waterproof electricians tape.
(6)
Install eleven wire clips (6) and screws (7).
(7)
Install new wire crimp connector to two forward facing clearance lamps and tape
connection with waterproof electricians tape.
(8)
Install six wire clips (1) and screws (2).
(9)
Route connector (9) with body lamps harness (8) up over left side frame rail.
(10)
Push connector (9) into male connector on lower left hand corner of body and turn
to the right until ring locks in place.
(11)
Test exterior body lamps for proper function.
2-22