TM 5-3895371-24 & Ps.Install stowage box. (Refer to para 2-11.)t.Install bumper. (Refer to para 2-9.)Section II. REPAIR OF SIDE WALKWAYS4-3. Remove Passenger Side Walkway. (Refer to fig. 4-12.)NOTELift off oil fill tubes from walkway.a .Remove four bolts, washers, and nuts (6) from two clearance lights (7). Snip wire at eachlight to remove from walkway.b.Remove three bolts, washers, and nuts (8) from walkway bracket to fender connection.c .Remove eight bolts and washers from four walkway to asphalt tank brackets (2) (3) (4) and(5). Do not remove the four lower bolts and washers from brackets (4) and (5); it is not necessary toremove the burner fuel tank.d.Remove walkway (1).4-4. Install Passenger Side Walkway. (Refer to fig. 4-12.)a.b.c.d.e.f.Set walkway (1) in place and aline mounting holes.Install eight bolts and washers thru walkway brackets (2), (3), (4), and (5).Install three bolts, washers, and nuts (8) thru walkway bracket to fender connection.Rejoin wires to clearance lights (7) with new wire crimp connectors.Install four bolts, washers and nuts (6) to clearance lights (7).Replace oil fill tubes to walkway.4-5. Remove Driver’s Side Walkway. (Refer to fig. 4-12.)a.Bleed air system; refer to TM 9-2320-273-10.b.Remove air lines (18) and (19) from "T" fitting (17) on back of air tank (16).c .Remove six bolts, washers, and nuts (11); three each on either end of storage box (15). Re-move storage box (15) with air tank (16) attached, from walkway (12).d.Remove four bolts, washers, and nuts (6) from two clearance lights (7).e.Snip wires at two clearance lights (7) and remove from walkway.4-13
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
