TM 5-3895-371-24 & P
Figure 3-77. Installing Motor Shaft Assembly.
TA 075950
(4)
Coat the OD of seal assembly (4) with Loctite pipe sealant and press new shaft seal into
shaft seal assembly (4) using an arbor press and 2-1/2 in. plug. Fill cavity in shaft seal between oil lips
approximately 3/4 full with multi-purpose grease.
(a)
Coat O-ring (7) lightly with a multi-purpose grease.
(b)
Install motor shaft (11) and ball bearing (14) assembly into mounting flange assem-
bly (8) using new O-ring (7) in mounting flange assembly (8).
(5)
Wrap shim stock or other thin material around shaft spline and carefully slide shaft seal
assembly (4) into place over motor shaft (11).
(6)
ft. (15 N-m).
Secure shaft seal assembly (4) with capscrews (2) and lockwashers (3). Torque to 11 lb
(Refer to fig. 3-78.)
TA 075951
Figure 3-78. Installing Shaft Seal Retainer.
3-66
