TM 5-3895-371-24 & P
Compressed air used for cleaning purposes will not
exceed 30 psi. Use only with effective chip guarding
and personal protective equipment (goggles/shield,
gloves, etc.).
(b)
Wash reworked cover in SD-2 solvent and dry with compressed air. Check against
tolerances in figure 3-44. If the reworked pump cover (21, fig. 3-4) does not fall within the tolerance
limits, it must be discarded.
NOTE
It is important that if either the inner or outer race is
to be replaced, the entire bearing be replaced.
(23)
If outer race of bearing (13) was removed during disassembly or if the inner race was
removed and replaced, install outer race in pump cover (21) using an arbor press and plug of proper size.
Figure 3-44. Pump Cow Rework specifications.
3-39
