TM 5-3895-371-24&P
(3)
To remove sleeve yoke (8) from release spring (1 1), remove cotter pin (9) from pin (10)
and remove from sleeve yoke (8).
(4)
Lift sleeve yoke (8) from release spring (11).
(5) Remove cotter pin (27).
(6)
Remove pin (23) to free latch bolt (25).
(7)
Unscrew four capscrews (24) and nuts (16); remove right latch bearing (20) and left
latch bearing (21).
(8)
Remove cover tongue (1) by unscrewing bolt (22) from nut (2). Slide bolt (22) from
cover tongue ( 1).
(9)
Lift cover tongue (1) from cover ( 12).
(10)
Remove four capscrews (5) and nuts (16); then remove left hinge bracket (6) and right
hinge bracket (7).
(11)
Remove strainer (28), inspect for damage; replace if necessary.
C.
Reassembly. (Refer to fig. 2-40.)
(1) Replace strainer (28).
(2)
and nuts (16).
Install left hinge bracket (6) and right hinge bracket (7); secure with four capscrews (5)
(3)
Replace cover tongue (1) on cover (12); secure with bolt (22) and nut (2).
(4)
Install right latch bearing (20) and left latch bearing (21); secure with four capscrews
(24) and nuts (16).
(5)
Secure latch bolt (25) in position with pin (23).
(6)
Replace cotter pin (27) to secure pin (23) in position.
(7)
Replace sleeve yoke (8) on release spring (11).
(8)
Install pin (10) through sleeve yoke (8).
(9)
Secure pin (10) in position with cotter pin (9).
(10)
Replace gasket (14) on cover ( 12).
(11)
Secure ring assembly (13) by tightening capscrew (15) and nut (19).
d.
Installation. (Refer to fig. 2-40.)
(1)
Set manhole cover assembly (17) on the cover opening on top of tank.
(2)
(4) as shown.
Position release spring (11) below the hinge, with sleeve yoke (8) in center of hinge pin
(3)
Install two cotter pins (3).
(4) Secure with handwheel (26).
2-90
