TM 5-3695371-24&P
Section XXVII. MAINTENANCE OF FILLING LINE
2-31. Filling Line.
a.
Removal. (Refer to fig. 2-36.)
(1) Remove clamp screw (8) and two cotter pins (3); then spread hinge clamps (7) to
remove it from the clamping ring (13).
(2)
Remove nut washer and capscrew holding clamping ring (13) and fill cap chain.
(3)
Remove fill cap (9) and slide clamping ring (13) off end of fill line (6).
(4)
Using strainer hook (10), remove strainer (12), from connector (11).
(5)
Remove U-bolt (2) by removing two washers and nuts (1).
(6)
Remove bracket (4) by removing four screws.
(7)
Unscrew fill line (6) from tank and remove gasket (5).
b.
(1)
Install gasket (5) and fill line (6).
(2)
Install bracket (4) and secure with four screws.
(3)
Install U-bolt (2) and secure with two washers and nuts (1).
(4)
Install clamping ring (13) and fill cap chain with capscrew, washer, and nut.
(5)
Insert strainer (12) into connector (11).
(6)
Install fill cap (9).
(7)
Install hinge clamp (7) over pins on clamping ring (13) and install two, cotter pins (3).
(8)
Install clamp screw (8) in hinge clamp (7) and fill cap (9).
2-82
