TM 5-3895-371-24 & P
Make sure that spray bar is set in locked-up position (fig. 4-10).
In steps b and c, three men are required to install the
platform; one on each side and one operating the jack.
Position a hydraulic jack under the center of the platform.
Position the platform (fig. 4-11) to line up its mounting holes with holes in vehicle frame;
then install two capscrews, nuts, and washers that fasten the platform to each frame rail.
Position auxiliary tank hoses in their proper position, as shown in figure 4-9.
Connect override control cable (3, fig. 4-8). Pass wire through hole in trunnion (1); then
tighten screws on top of the trunnion. Secure cable with clamp (2).
Connect platform (fig. 4-7) to left rear fender and brace and secure with three capscrews,
nuts, and washers.
Install step and secure to left rear fender and platform with six capscrews, nuts, and washers.
Connect right rear fender to platform with three capscrews, nuts, and washers.
Connect electrical fitting (fig. 4-6) to control box and secure with knurled nut inside box.
Connect eight wires to terminal strip. Color of each wire must match the color of the wire
that is already connected to the terminal strip. That is, the red wire must go to the terminal that has
another red wire on it; the white wire to the terminal that has another white wire on it, etc.
Install control box cover (fig. 4-5) and secure with screws (2); then install knob (1) and
secure with washer and nut (4). Connect air line (3) to control box.
Connect two rods (5, fig. 2-60) to valve control arm and secure wit., cotter pins.
Connect linkage (3, fig. 44) and secure with cotter pin (2).
Connect two lines to cylinder (fig. 2-22).
Connect pipe nuts (1 and 2, fig. 4-3).
Install right side platform (fig. 4-2) and secure with nine capscrews (1) nuts and washers at
top and bottom of plate; and two capscrews (2), nuts, and washers through the side step.
Install right side guard rail (fig. 4-1) and secure with three capscrews (2), lockwashers (3), and
nuts (4) at top and bottom. Install capscrews (5), nut, and washer that fasten guard rail to frame.
Install blower assembly. (Refer to para 2-35.)