TM 5-3895-371-24 & P
k.
Remove control box cover by removing nut (4), washer, valve knob (1), and sixteen screws
(2).
NOTE
In step I, observe that the wires being disconnected
are the same color as the wires remaining on each
terminal. Therefore it is not necessary to tag the wires
for identification.
l.
Disconnect eight wires (fig. 4-6) from terminal strip.
m.
Disconnect electrical fitting by removing knurled nut inside control box; then pull the eight
wires out of box.
Figure 4-6. Disconnect/Connect Terminal Strip Wires.
4-7