TM 5-3895-373-20
REFERENCE INFORMATION
SCREED BURNER FUEL SYSTEM
Refer to TM 5-3895-373-10 for engine starting and equipment operating procedures. Refer to paragraph 2.10 for
connecting and disconnecting STE/ICE-R test set to DCA.
Do not allow fuel to accumulate on
screed
plate.
Igniting
burner
in
presence of excess fuel will cause a
minor explosion and could cause injury
to personnel. If fuel is seen on screed
plate, raise screed to drain off excess
fuel.
Screed fuel pump switch is located on left hand screed
control panel.
Each burner chamber is equipped with an inspection port
(shown below). To check for fuel spray from fuel nozzle,
rotate cover plate and insert a probe in exposed port.
When probe is in port, place burner control switch in
spray position for 2 or 3 seconds.
If probe gets wet with fuel, spray nozzle is spraying fuel.
Fuel nozzle ports are extremely small. Any particulate
contamination can clog fuel nozzle.
Dispose of fuel collected in pail in accordance with local
procedures.
2-351
