f.
Close the gauge panel left and right access
doors.
(1)
Close access door.
(2)
Turn the latch 900 and lower to lock.
2.24.3
Removing Screed Steps.
a.
Grab the screed steps at the back edge of the
top step. Lift and pull steps up and away from
the tractor.
b.
With the screed steps full back, slide the steps to
the right to separate the hinge pin from the
hinge.
TM 5-3895-373-10
2.24.4
Installing Screed Steps.
a.
Position the screed steps to align the hinge pin
with the hinge.
b.
With the screed steps full back, slide the steps to
the left, so the hinge pin fits into the hinge.
c.
Lift and push the screed steps forward until fully
seated.
2.24.5
Remove Access Covers.
a.
Push in on one end of the latch and lift the other
end and turn 90°.
b.
Lift the access cover by the hand ports until the
cover retaining brackets on the bottom of the
access cover clear the bottom edge of the
access port.
2.24.6 Install Access Covers.
a.
Center the access cover into the access port.
b.
Press down on the hand ports of the access
cover until the cover retaining brackets on the
bottom edge of the access cover are fully seated
onto the bottom edge of the access port.
c.
Press the access cover against the port wall
near the latch.
d.
Turn the latch 90° and lower to lock.
2-55
