Figure 2-21. Remove/Install Bottom Bar On-Off Cylinder

b. Installation of Bar Shifting Control Cylinder

Figure 2-22. Remove/Install Top Bar On-Off Cylinder.

TM-5-3895-371-24P Melter Asphalt Skid Mounted Hot Oil Circulating 750 GPH Chausse Model STMD-3000A Manual
Page Navigation
63

TM 5-3895-371-24 & P LEGEND: 1. PIN 2. COTTER PIN (2) 3. END CAP 4. CYLINDER 5. END CAP 6. PIN 7. YOKE 8. LOCKNUT (2) 9. FITTING (2) 10. BOLT 11. YOKE TA 075827 Figure 2-21. Remove/Install Bottom Bar On-Off Cylinder. d. Installation of Bottom Bar On-Off Cylinder. (Refer to fig. 2-21.) (1) Connect yoke (7) to control linkage and secure with pin (6) and cotter pin (2). (2) Adjust length of yoke (11) to line up holes in yoke with hole in control linkage; then install pin (1) through yoke (11) and secure with cotter pin (2). (3) Tighten locknut (8) on yokes (11) and (7). (4) Reconnect two air line fittings (9). 2-56

Privacy Statement
Press Release
Contact