TM 5-3895-371-24 & P
(2)
Push wire harness (45) up thru bottom of box (47) and fasten with harness clamp (46).
(3)
Push wire (42) up thru bottom of box (47); rejoin wires with new crimp connector.
d.
Assembly. (Refer to fig. 2-14.)
(1)
If new toggle switches are being installed, screw on spacer (21) taken from old switch,
(2)
If indicator lamps (11) are being installed screw on two hex nuts and washers (35).
(3)
Snap in bulb connections (12) and (14) to lamps (11).
(4)
Install new fuse if necessary and screw fuse connector (28) together.
(5)
Rejoin flasher wire (37) with new crimp connector.
(6)
Install ground wire (3) to clip (2) and flasher with bolt (1) and two lock nuts (4). Con-
nect other end with capscrew and nut (43).
(7)
Install black wire (7) and red wires (36) and (5) to toggle switch (6) “MATERIAL LOW
LEVEL ON OFF” control; tighten screws.
(8)
Install orange wire (33) and red wires (30) and (32) to toggle switch (34) “BITUMETER
WHEEL UP DOWN”; tighten screws.
(9)
Install white wire (27), red wire (30) and black wires (29) and (31) to toggle switch (26)
“ON OFF”; tighten screws.
(10) Install blue wire (25), black wire (23), and red wires (19) and (24) to toggle switch (22)
“SHIFT”; tighten screws.
(11)
Install purple wire (20), red wire (19), and red/white wire (18) to toggle switch (17)
“TURN UP”; tighten screws.
(12)
Insert five toggle switches thru panel faceplate (9) from back in positions illustrated;
install hex nuts (16) to affix.
(13)
Install panel faceplate (9) to box (47); aline holes at bottom front edge and mount with
two screws (44) and lockwasher (40). As panel faceplate is set in position take care that no wires are
caught between the box and panel faceplate.
2-40
