TM 5-3895-371-24 & P(8) Install air supply tank with two bolts in clamp brackets (fig. 3-114).(9) Install two air lines to air supply tank (fig. 3-114).(10) Install three clamp bolts holding air lines to tank (fig. 3-106).(11) Install three bolts at center of fender (fig. 3-107).(12) Install fender to tank brace bolt (fig. 5-3).(13) Install control box air line (3) (fig. 4-5).(14) Install step to rear fender (fig. 5-3).(15) Install asphalt pump (para 3-7).(16) Install low pressure burners (para 2-39).(17) Install low pressure burners air inlet tube (para 2-39).(18) Install intake valve lever (para 2-30).(19) Install vacuum flow lever and gage plate (fig. 3-109) with four capscrews (11), two nuts(14), and two nuts (15).(20) Install two smoke stacks (para 2-28).(27) Install eight bolts thru walkway and brackets (para 4-4).(22) Install fuel tank (see para 2-27 b).(23)Set intake hoses and hand spray hose in place (fig. 4-9).(24) Install four tank brackets to sub-frame bolts (fig. 4-11).(25) Install one bolt at rear of right fender brace (fig. 3-108).(26) Install three center fender bolts (fig. 3-107).(27) Install two fuel lines to tank and secure with three clamps and bolts (fig. 3-106).(28) Install eight nuts to top of tank to frame spring mounting bolts (fig. 3-105). Tightennut until it just touches spring top then pull down one inch.(29)two screws (8).Install microswitch (2, fig. 3-110) with attached bracket (3) secure bracket to tank with(30) Install two clamps (4 and 6, fig. 3-110) to secure cables for microswitch (2). Fasteneach pair of clamps to tank with screws (5 and 7).(37) Install hydraulic motor. (Refer to para 3-6.)3-100
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business