TM 5-3895-373-34
2.63
REPLACE AND ADJUST AUGER/CONVEYOR DRIVE CHAIN - Continued.
B.
CLEAN.
1.
CLEAN AUGER/CONVEYOR DRIVE CHAIN
AND COMPONENT PARTS.
Cleaning solvent, P-D-680, is TOXIC and
flammable. Wear protective goggles and
gloves. Use only in a well ventilated area.
Avoid contact with skin, eyes, and clothes,
and do not breathe vapors. Keep away from
heat or flame. Never smoke when using
solvent; the flashpoint for Type III cleaning
solvent is 200°F (93,3°C). Failure to do so
may result in injury or death to personnel.
If personnel become dizzy while using
cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or
clothes, flush with cold water. If solvent
contacts eyes, flush eyes with water and get
immediate medical attention.
a.
Soak
auger/conveyor
drive
chain
in
cleaning solvent. Use a cleaning brush to
remove
grease
buildup.
Dry
the
auger/conveyor drive chain with a cleaning
cloth.
b.
Use a cleaning cloth soaked with cleaning
solvent to clean all cover plates.
c.
Use a parts cleaning brush and cleaning
solvent to remove any hard deposits.
2.
CLEAN CAP SCREWS.
Thread locking compound solvent can cause
eye damage. Wear safety goggles/glasses
when using. Avoid contact with eyes. If
solvent contacts eyes, flush eyes with water
and get immediate medical attention.
a.
Clean threads of cap screws with thread
locking compound solvent.
b.
Dry with a clean, cleaning cloth.
GO TO NEXT PAGE
2-866