TM 5-3895-385-23-2
0394
Light/Horn Wiring Harness Removal -- Continued.
3. Remove two screws (Figure 2, Item 2), and disconnect W19 J2 and W19 J3 (Figure 2, Item 3) from horn
button (Figure 2, Item 4).
4. Disconnect W19 J5 and W19 J6 (Figure 2, Item 9) from worklight rocker switch (Figure 2, Item 1).
CAUTION
Tag and label all electric cables and connections prior to removal. Electric cables must be
installed correctly for proper operation. Failure to comply will cause damage to equipment.
NOTE
It will be necessary to remove wire ties during removal and remove wiring harness from
sheathing.
5. Remove W19 from pedestal.
NOTE
There are two wring harnesses attached to the horn and the worklights wiring harness. Leave the
main wiring harness in place when removing lights horn wiring harness.
6. Disconnect W19 J7 (Figure 2, Item 8) from W1 J14 (Figure 2, Item 7).
7. Disconnect W19 J4 (Figure 2, Item 5) from horn (Figure 2, Item 6), and remove lights horn wiring harness
from BMPM.
END OF TASK
Light/Horn Wiring Harness Installation
1. Connect W19 J4 (Figure 2, Item 5) onto horn (Figure 2, Item 6).
2. Connect W19 J7 (Figure 2, Item 8) onto W1 J14 (Figure 2, Item 7).
3. Install W19 into sheathing and pedestal, and connect W19 J5 and W19 J6 (Figure 2, Item 9) onto worklight
rocker switch (Figure 2, Item 1).
4. Connect W19 J2 and W19 J3 (Figure 2, Item 3), and install two screws (Figure 2, Item 2) onto horn button
(Figure 2, Item 4).