BITUMINOUS MATERIAL PAVING MACHINE (BMPM)
SPN#110, FMI#2 ― COOLANT TEMPERATURE DATA ERRATIC, INTERMITTENT, OR INCORRECT
References ― Continued
WP 0357, Vol 2
WP 0448, Vol 3
WP 0277, Vol 2
WP 0451, Vol 3
WP 0332, Vol 2
WP 0333, Vol 2
Engine off (TM 5-3895-385-10)
WP 0334, Vol 2
Engine hood assembly removed (WP 0433, Vol 2)
All active fault codes must be investigated prior to replacing the engine Electronic Control Module
(ECM). Failure to comply may cause damage to equipment.
After the engine has been turned off for at least 8 hours, if the engine coolant temperature is
higher than the intake manifold temperature by a measureable amount when the keyless engine
switch is turned ON, this error will be displayed. Also, if the coolant temperature sensor does not
detect an increase in coolant temperature during the first 10 minutes of engine operation, this
error will be displayed.
Table 1. SPN#110, FMI#2 ― Coolant Temperature Data Erratic, Intermittent, or Incorrect.
TEST OR INSPECTION
1. Multiple errors displayed.
1. Install fuse box (WP 0277, Vol
2. Connect battery cables (WP
0357, Vol 2).
3. Turn keyless engine switch to
AUX position (TM 5-3895-385-
10), but do not start engine.
Wait for 30 seconds.