INSTALL BURNER CHAMBER ASSEMBLY.
Install gasket (80). Align mounting holes in
gasket and extension screed base (82).
Install burner chamber assembly (77). Align
mounting holes in burner chamber with gasket
(80) and extension screed base (82).
locking compound can cause eye
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
Install lockwashers (79) on hex head cap
screws (78). Apply sealing compound to
threads of cap screws.
lockwashers (79). Tighten cap screws to 37
lb-ft (50 Nm).
Insert shield (76) into extension screed (14).
Slide shield inward, between burner chamber
assembly (77) and shield brackets.
Instruct second person to hold shield (76) up
against shield brackets and align mounting
Apply thread locking compound (Item 14,
Appendix B) to threads of bolts (75). Insert
bolts down through shield brackets and shield
Install flat washers (74), lockwashers (73), and
hex nuts (72). Tighten hex nuts to 19 lb-ft (26
GO TO NEXT PAGE