CLEAN - Continued.
CLEAN MAIN FRAME AT BEARING PLATE
MOUNTING SURFACES AND DRIVE SHAFT
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
m cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
Clean paving machine main frame at bearing
plate mounting surfaces using cleaning cloths in
cleaning solvent. If necessary, use a wire
scratch brush to remove built-up dirt and
residue. Give special attention to cap screw
holes. Wipe away all residue.
Clean inner edges and area around drive shaft
throughways with cleaning solvent. Wipe away
all residue with a cleaning cloth.
Dry all parts with a cleaning cloth.
INSPECT DRIVE SHAFT FOR WEAR OR
Inspect drive shaft (18) for cracks or bends.
Replace the drive shaft if cracked or bent.
Inspect key slots A for worn or broken edges.
Replace drive shaft (18) if slot edges are broken
GO TO NEXT PAGE