REPLACE/REPAIR CONVEYOR DRIVE SHAFT, BEARING UNITS, AND SPROCKETWHEELS- Continued.
CLEAN ALL METAL PARTS.
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
m cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
Rinse and clean all metal parts in cleaning
solvent. Give special attention to bearing
lubrication holes. Wipe away all residue with a
Clean lubrication fittings of old grease.
Thread locking compound solvent
can cause eye damage. Wear safety
goggles/glasses when using. Avoid
contact with eyes. If solvent contacts
eyes, flush eyes with water and get
immediate medical attention.
Clean all fastener threads using thread locking
Dry all parts with a cleaning cloth.
GO TO NEXT PAGE