REMOVE - Continued.
SUPPORT HOPPER WING WITH OVERHEAD
If C-clamps and chain assemblies are
not installed, continue with step 3. If
removing the hopper lift cylinder,
fully lower the hopper wing and
proceed to step 4.
Attach two C-clamps (20) to hopper wing (18).
Position C-clamps 1 ft (0,3 m) from each end of
hopper wing. Tighten C-clamps securely to
Hopper wing weighs 875 lbs (397 kg).
To avoid personal injury, ensure all
condition and are of correct capacity.
Ensure overhead hoist is in good
working condition and hooks are
positioned correctly. Lifting hooks
must not be side loaded. Damage to
equipment and personnel injury may
result from unexpected movement of
Hook up chain assemblies (21) to C-clamps (20)
and overhead hoist. Take up the slack on the
c. Ensure hopper wing (18) is fully lowered.
GO TO NEXT PAGE