INSTALL DOWEL PINS, CASES, AND END
PLATES ONTO FLOW DIVIDER.
flammable and can be an irritant to
system. Avoid prolonged exposure.
Eye protection and rubber gloves
must be worn when working with
Dip all metal flow divider parts being assembled
in clean hydraulic oil prior to assembly.
Install dowel pins (24 and 25) into end plates
petrolatum. Install preformed packings into end
plate (20) and spacer plate (22).
Assemble end plates (20), spacer plate (22), and
cases (21). Ensure preformed packings (23) are
seated in seal grooves.
Thread locking compound can cause
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
Apply thread locking compound to hex head cap
Install hex head cap screws (18) through flow
Install hex nuts (19) on hex head cap screw
threads. Tighten hex nuts to 15 lb-ft (20 Nm).
GO TO NEXT PAGE