ASSEMBLE - Continued.
INSTALL ELECTRICAL CABLE.
Insert wire ends of electrical cable into
electrical housing (24). Thread electrical
box connector (18) into electrical housing.
Install and tighten clamp screws (19) in
electrical box connector (18).
Install stripped ends of harness lead wires
in terminal box terminals. Tighten terminal
Make sure gasket (16) is positioned in
plate (15). Install plate and identification
plate (14). Install and tighten screws (13).
INSTALL HIGH SPEED SHIFT VALVE ONTO
Install sleeve spacers (10) on bolts (9).
Install ground wire (11) on one of the two
Thread locking compound can cause
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
Apply thread locking compound to threads
of bolts (9).
Install high speed shift valve (3) and secure
with bolts (9). Install bolt with ground wire
(11) in left hand mounting hole of mounting
Tighten bolts (9) to 19 lb-ft (26 Nm).
GO TO NEXT PAGE