9. INSTALL GASKET, AUTO ADVANCE PISTON HOUSING ASSEMBLY, AND CAP NUT TO FUEL INJECTION PUMP AND ASSEMBLE SEALING RINGS AND BALL TO FLUID PASSAGE BOLT.

8. INSTALL PISTON, SPRING, SHIM, SPRING CAP, AND HEX HEAD CAP SCREW INTO AUTO ADVANCE HOUSING

10. INSTALL ROTOR HEAD ASSEMBLY TO FUEL INJECTION PUMP

TM-5-3895-373-34 Paving Machine Bituminous Material Crawler Mounted Diesel Engine Driven Manual
Page Navigation
299

TM 5-3895-373-34 E. ASSEMBLE - Continued. 9. INSTALL GASKET, AUTO ADVANCE PISTON HOUSING ASSEMBLY, AND CAP NUT TO FUEL INJECTION PUMP AND ASSEMBLE SEALING RINGS AND BALL TO FLUID PASSAGE BOLT. a. Use a stud remover and setter to install stud (69). b. Install gasket (68) and auto advance piston housing assembly (67). c. Lubricate sealing rings (63) with clean calibrating fluid. Be careful not to damage preformed packing when sliding over threads. Sharp edges of thread can cut or damage preformed packing. Damaged preformed packing will cause leakage and affect performance. d. Install sealing rings (63) and ball (64) onto fluid passage bolt (62). e. Set assembled fluid passage bolt (62) aside for later installation. f. Install flat washer (66) and cap nut (65) hand tight. GO TO NEXT PAGE 2-275

Privacy Statement
Press Release
Contact