INSTALL SEALING RING.
Lubricate sealing ring (147) with clean calibrating
Use a guide from DPA workbench tool kit and a
plastic hammer to tap in sealing ring (147).
Install fuel injector pump housing (146) into jig,
with top of fuel injection pump housing facing up.
Install jig into bench vise.
ASSEMBLE DRIVE PLATE, BACK PLATE, AND
INSERTS ONTO GOVERNOR WEIGHT CAGE
DRIVE SHAFT ONTO ASSEMBLED GOVERNOR
Assemble inserts (142) onto governor weight
Install drive plate (141), small diameter end
facing down, onto governor weight cage (139).
Position back plate (140) notches to slide over
Rotate back plate (140) until internal lip aligns
with lip on drive plate (141).
GO TO NEXT PAGE