REPLACE/REPAIR FUEL INJECTION PUMP - Continued.
Pull drive hub (104) from fuel injection pump.
Remove governor weight cage (136) as an
assembly from fuel injection pump.
REMOVE DRIVE SHAFT SEAL, BACK PLATE,
DRIVE PLATE, INSERTS, GOVERNOR WEIGHTS,
THRUST WASHER BEARING, AND THRUST
Stand drive shaft (137) vertically, with drive shaft
seal (138) facing up.
Remove drive shaft seal (138). Discard drive
Lift governor weight cage (139) until back plate
(140) is level with groove on drive shaft (137).
Hold back plate (140) and turn governor weight
cage (139) until back plate notches are aligned
with rivet heads on governor weight cage.
GO TO NEXT PAGE