INSTALL - Continued.
INSTALL ENGINE AND PUMP ASSEMBLY
AND PUMP DRIVE GEARBOX INTO ENGINE
AND ENGINE MOUNTS.
approximately 2, 000 lbs (908 kg).
Ensure chain assembly and sling strap
are in good condition and are of correct
positioned between pump drive gearbox
and flywheel housing. Chain assembly
must be attached securely to front lifting
bracket securely. Failure to do so may
result in the engine and pump assembly
shifting causing equipment to fall and
Guide sling strap (184) between pump drive
gearbox (185) and flywheel housing (186).
Attach chain assembly (187) to front lifting
bracket (188) and to the loops on sling strap
Attach overhead hoist hook (189) to the lifting
center of chain assembly (187). Take up slack
in chain assembly and sling strap (184).
Do not allow heavy engine and pump
assembly to swing from hoist while
raising engine and pump assembly off
cribbing. Engine and pump assembly
may strike personnel and cause serious
injury if allowed to swing.
Lift engine and pump assembly (190) up off
cribbing and position engine and pump
GO TO NEXT PAGE