INSTALL FUEL LINES.
Before connecting any fuel lines, clean all fittings
Adjust induction heater fuel pipe (21) and fuel
inlet hose (22) so that clamps (14, 19, and 20)
align with the proper holes.
Attach clamps (19 and 20) to cylinder head
assembly (15) with washer (18), lockwasher (17)
and screw (16).
Attach clamp (14) to cylinder head assembly
(15) with lockwasher (13) and screw (12).
Tighten screw (16) to 21 lb-ft (28 Nm).
Tighten screw (12) to 42 Ib-ft (57 Nm).
INSTALL MUFFLER SUPPORT BRACKET.
a. With the assistance of a second person, support
the weight of muffler support bracket (7).
Thread locking compound can cause
goggles/glasses when using. Avoid
contact with eyes. If compound
contacts eyes, flush eyes with water
and get immediate medical attention.
b. Apply thread locking compound to threads of
socket head cap screws (11).
c. Install socket head cap screws (11), flat washers
(10), lockwashers (9), and hex nuts (8).
d. Tighten hex nuts (8) to 37 Ib-ft (50 Nm).
GO TO NEXT PAGE