REPAIR ELECTRICAL HARNESSES - Continued.
REPAIR RING, TONGUE, AND SPADE
Ring, tongue, and spade terminals
are identically repaired. In this
paragraph, a ring terminal is shown
as an example.
Remove terminal (38) from wire (39) by
cutting directly behind edge of shrink tubing
(40). Discard terminal.
Slide new shrink tubing (40) onto wire (39).
Use wire strippers to strip approximately
0.25 in. (6,3 mm) of wire (39).
Crimp new terminal (38) onto wire (39)
using crimp tool.
Solder wire (39) core on terminal per MIL-
STD-2000A with soldering iron.
GO TO NEXT PAGE