TM 5-3895-373-20
7.17.
REPLACE DCA AND PRESSURE TRANSMITTERS - Continued.
A.
REMOVE.
1.
REMOVE DCA HOUSING COVER.
a.
Using flat head bit from screwdriver bit set,
remove screws (1) and lift housing cover
(2) from DCA housing.
b.
Remove machine screws (3), electrical
component cover (4), flat washers (5),
and hex nuts (6) from DCA harness
connector (7).
c.
Tag and disconnect wires 151 (8) and 322
(9) from engine crank toggle switch (10).
d.
Tag and disconnect wires 314 (11) and
wire 315 (12) from zero offset toggle
switch (13).
NOTE
Toggle switch "ON" markings are
positioned toward front of housing
cover (2).
e.
Remove hex nuts (14), lockwashers (15),
engine crank toggle switch (10) and zero
offset toggle switch (13).
GO TO NEXT PAGE
7-118