REPAIR/REPLACE OPERATOR CONTROL CONSOLE ASF Continued.
INSTALL - Continued.
INSTALL PANEL SEAL AND SWITCH PANEL
ASSEMBLY ONTO OPERATOR CONTROL
Adhesive is TOXIC and extremely
flammable. Keep away from heat,
sparks, and open flames. Use only in
well ventilated areas. Do not breathe
vapors or swallow and avoid contact
with eyes and skin. Failure to do so
may result in injury or death to
If personnel become dizzy while
using adhesive, immediately get fresh
personnel swallow adhesive, do not
induce vomiting. Get immediate
contacts eyes, flush eyes with water
for 15 minutes and get immediate
contacts skin, wash thoroughly with
soap and water.
Apply adhesive to seal area on operator
control console (8) where switch panel
assembly (67) will be installed.
Install panel seal (75) over adhesive on
operator control console. Line up holes in
panel seal with holes drilled in operator
Ensure wires are routed through
conduit mounting flange as tagged.
Install switch panel assembly (67) harness
into operator control console assembly (8).
Leave switch panel assembly face down on
GO TO NEXT PAGE