INSTALL FUEL FILTER ELEMENT.
Cleaning solvent, P-D-680, is TOXIC
and flammable. Wear protective
goggles and gloves. Use only in a
well ventilated area. Avoid contact
with skin, eyes, and clothes, and do
not breathe vapors. Keep away from
heat or flame. Never smoke when
using solvent; the flashpoint for Type
HI cleaning solvent is 200°F (93,3°C).
Failure to do so may result in injury
or death to personnel.
If personnel become dizzy while
using cleaning solvent, immediately
get fresh air and medical help. If
solvent contacts skin or clothes,
flush with cold water. If solvent
contacts eyes, flush eyes with water
and get immediate medical attention.
Use cleaning solvent and lint-free cloth to
clean inside of bottom cover (8) and inside
of fuel filter head (11).
Install gasket (13) and thumbscrew (12) on
bottom cover (8).
Fuel is very flammable and can
explode easily. To avoid serious
injury or death:
Always wear safety glasses/goggles
at all times.
Keep at least a B-C fire extinguisher
within easy reach when working with
fuel or on a fuel system.
Do not work on fuel system when
engine is hot; fuel can be ignited by a
Post signs that read "NO SMOKING
WITHIN 50 FEET" when working with
open fuel lines or fuel tanks.
Coat bottom gasket (9), top gasket (10),
and seal (16) with clean fuel.
Install bottom gasket (9) into bottom cover
Seat fuel filter element (7) in bottom cover
Install top gasket (10) into fuel filter head (I
Install seal (16) into filter head (11).
Install flat washer (15) and preformed
packing (14) onto bolt (6).
Squarely seat fuel filter element (7) and
bottom cover (8) into filter head (11).
Install bolt (6) through filter head (11) and
GO TO NEXT PAGE