TM 5-3895-373-20
REFERENCE INFORMATION
AUGER/CONVEYOR CIRCUIT
Open centertop right and centertop left access doors per TM 5-3895-373-10 to gain access to reverse solenoid harness.
To avoid reversing polarity to the voltmeter, connect
negative test lead to equipment ground and use positive
lead to probe for voltage.
Gain access to auger/conveyor reverse switch terminals
per paragraph 15.2, step a.
Refer to the electrical system diagram at the end of the
manual for equipment wiring details.
Refer to paragraph 7.21 for harness and lead wire repair.
After completing diagnostic checks, close center top left
and center top right access doors per TM 5-3895-373-
10. Install screed control panel per paragraph 15.2.
2-319