CONTROL HANDLE, BRAKE, AND STOP/RESUME CIRCUIT
Refer to TM 5-3895-373-10 for engine starting and equipment operating procedures. Refer to paragraph 2.10 for
connecting and disconnecting STE/ICE-R test set to DCA.
If both brakes fail to release, the engine will bog
down when control handles are placed in forward
or reverse direction.
Refer to paragraph 1.20 for a description of
control handle and brake circuits.
Refer to the electrical system diagram at the end
of the manual for equipment wiring details.
To avoid reversing polarity to the voltmeter,
connect negative test lead to equipment ground
and use positive lead to probe for voltage.
Open center top right and center top left access
doors per TM 5-3895-373-10 to gain access to