WORK LIGHT CIRCUITS
Refer to TM 5-3895-373-10 for engine starting and equipment operating procedures.
Refer to paragraph 2.10 for connecting and disconnecting STE/ICE-R test set to DCA.
The diagnostic procedure is the same for all
three work light circuits. Use this diagnostic
procedure to troubleshoot any one of the three
work light circuits.
Work light voltage is available at work light
switches when ignition switch is on or off.
Refer to paragraph 7.7forgauge panel repairs.
Reference electrical schematic at back of
manual for complete circuit wiring.
Remove gauge panel per paragraph 7.6 to gain
access to work light switch terminals.