15.17. REPLACE/REPAIR FEED LIMIT SWITCH PADDLE ASSEMBLY - Continued.
REPAIR - Continued.
Remove machine screws (30) from clamp
assembly (31). Remove clamp assembly.
Cut spiral wrap (32) off of coil cord (28).
Unscrew connector body (33) from pin coupling
(34) and move threaded retainer ring (35) and
connector body off of the pin coupling.
Slide plastic seal (36) and rubber grommet (37)
off of the wires on the back of pin coupling (34).
Tag coil cord (28) wire positions with pin
numbers at the back of pin coupling (34).
Cut the wires at pin coupling (34).
Slide rubber grommet (37), plastic seal (36),
connector body (33) and threaded retaining ring
(35) from coil cord (28).
If any part of the connector is damaged, replace
GO TO NEXT PAGE