15.16. REPLACE/REPAIR ENDGATE HAND LEVER ASSEMBLY - Continued.
INSTALL - Continued.
m. Ensure pawl (26) is fully engaged with teeth of
ratchet (7) with latch grip (17) released.
Squeeze latch grip and ensure pawl disengages
from ratchet teeth.
If pawl (26) does not engage and disengage
properly, remove machine screw (14), hex nut
(15), and flat washers (16). Screw rod end (18)
in or out on pawl rod (23) as required.
Secure rod end (18) to latch grip (17) with
machine screw (14), flat washers (16), and hex
If necessary, repeat steps m, n, and o until pawl
(26) and ratchet teeth engage and disengage
GO TO NEXT PAGE