REPLACE SCREED CONTROL BOX - Continued.
INSTALL - Continued.
Carefully feed valve harness (68) wires, in small
bundles, into screed control box.
Install electrical box connector (66) into rear of
screed control box.
Install electrical lock nut (67) over valve harness
(68) wires and onto electrical box connector (66).
Tighten electrical box connector.
Install quick disconnect connector (65) through
bottom of screed control box.
Use a jewelers screwdriver to install machine
screws (61), lockwashers (63), protective cap
(64), and hex nuts (62).
GO TO NEXT PAGE