REPLACE SCREED CONTROL BOX - Continued.
REMOVE - Continued.
Left and right hand screed control
panel layouts are reversed (left to
right) from one another. Left hand
screed control box panel has a fuel
pump switch, indicator light, and an
additional circuit breaker connection
on buss bar.
Ensure switches are tagged for
reassembly. Not all switches
function in the same manner.
Remove switches (17 through 27) from
screed control panel (8) by removing hex
nuts (28), lockwashers (29), and dust and
moisture boots (30). Tag switches for
placement at reassembly. Pull switches
from rear of screed control panel.
Remove hex nuts (31). Refer to legend
and illustration. Discard lockwashers and
dust and moisture boots.
Remove indicator lights (32 through 36)
from screed control panel (8) by removing
lockwashers (37) and orings (38). Pull
indicator lights from front of screed control
panel. Refer to legend and illustration.
Discard lockwashers and orings.
Remove emergency stop switch (39) from
screed control panel (8) by removing
pushbutton (40), bezel (41), bezel gasket
(42), and adjustment ring (43). Pull
operator switch (44) from screed control
panel (8) and remove lamp (45),
lampholder (46), direct voltage adapter
(47), and contact blocks (48). Do not
discard bezel gasket (42).
Remove panel lamp unit (49) by pressing
with a finger from behind screed control
Fuel pump switch (LH only)
Panel light switch
Main screed blower switch
Main screed burner control switch
Feeder control switch
Flow gate switch
Auger/conveyor reverse control switch
Tow point movement switch
Extension screed control switch
Extension screed blower switch
Extension screed burner control switch
Dust and moisture boot
Screed fuel pump indicator light (LH only)
Main creed burner on indicator light
Main screed burner on indicator light
Main screed blower indicator light
Extension screed burner on indicator light
Extension screed blower indicator light
Emergency stop switch
Direct voltage adapter
Panel lamp unit
GO TO NEXT PAGE