TM 5-3895-373-20
14.7.
REPLACE BURNER GLOW PLUG.
This task covers:
a. Remove
b. Install
INITIAL SETUP
Tools:
References:
General mechanics automotive tool kit
TM 5-3895-373-24P
(Item 54, Appendix E)
Torque wrench (Item 68, Appendix E) Equipment Condition:
Extension screeds fully extended per TM 5-3895-373-10.
Materials/Parts:
Electrical insulating varnish (Item 32, Appendix C)
Glow plug
NOTE
There are four burner glow plugs
installed on the paving machine.
This procedure can be used to
remove the burner glow plug from
any or all of the four screed burners.
A.
REMOVE.
1.
REMOVE TERMINAL NUT (1) AND RING
TERMINAL (2) FROM GLOW PLUG (3).
DISCARD TERMINAL NUT.
2.
REMOVE AND DISCARD GLOW PLUG
(3) AND METALLIC GASKET (4).
B.
INSTALL.
1.
INSTALL METALLIC GASKET (4) ON
GLOW PLUG (3) AND INSTALL GLOW
PLUG. TIGHTEN TO 33 lb-ft (45 Nm).
GO TO NEXT PAGE
14-57