TM 5-3895-371-24 & P
Section XXIII. MAINTENANCE OF BURNER FUEL TANK
2-27. Burner Fuel Tank.
a.
Removal. (Refer to fig. 2-30.)
(1)
Open two draincocks and drain fuel.
(2)
Remove two capscrews and remove access plate.
NOTE
Mark fuel lines for re-installation identification.
(3)
Disconnect two fuel lines at fuel tank.
(4)
Loosen two clamps that support the tank by removing capscrew, nut, and lockwasher
from each; then remove tank.
b.
lnstallation. (Refer to fig. 2-30.)
(1)
Place fuel tank in clamps and secure each clamp with a capscrew, nut, and lockwasher,
but not tight at this time.
(2)
Connect two fuel lines to tank.
(3)
Tighten clamp capscrews and nuts.
(4)
Install access plate and secure with two capscrews.
2-71