TM 5-3895-371-24 & P
Repair of Universal Joint. (Refer to fig. 2-10.)
To remove shaft refer to para 2-14 a.
Place drive shaft section in a suitable vise.
(3) Remove four lockrings.
Tap on top of yoke (as shown in illustration) to drive upper bearing out until cross
bottoms on shaft.
Turn drive shaft section over and repeat step (4).
Lift out cross and remove two bearing cups, one from the top and one from the bottom.
Repeat steps 3, 4 and 5 above to remove the other two bearing cups.
Position cross in yoke.
Replace Drive Shaft Universal.